Cart 0
10 GPM 1 in. Water Heater Shield

10 GPM 1 in. Water Heater Shield

Article Number:
  • $ 19900

FDA-grade polypropylene filter housing features thick walls for increased durability . Double o-ring design for superior leak proofing . High-quality pressure gauge monitors pressure loss indicating the need for a filter change . Pressure relief button on the inlet side of the cap makes filter changes quick and easy . 100% FDA grade polypropylene fibers are made for wide chemical compatibility . Replace filter annually or when water pressure has dropped 10 psi below psi recorded upon installation . Some geographic locations may require filter replacement sooner than one year . If initial water pressure is greater than 80 psi, install pressure regulator before the water heater shield . 5-micron filter with food-grade polyphosphate and silicate media keeps water heater clean, is easy to maintain, reduces sediment and inhibits scale and corrosion . Designed for all water heaters . Easy to install; includes installation bracket . Operating temperature range 40? to 100?F . Maximum pressure 80 psi

The Pelican Water 10 GPM 1 in. Water Heater Shield is installed on the feed water line just prior to the water heater (tankless or traditional). The 5-micron filter removes dirt, rust, salt, silt and sediment. Siliphos media within the filter chamber prevents scale and stops corrosion by forming a thin protective layer on the metallic surfaces within the water heater. The filter housings are tested and certified by NSF International to NSF/ANSI Standard 42 and 58 for material and structural integrity requirements and are FDA approved. Its 5-micron filter reduces dirt, rust, silt and sediment particles down to 1/20th the size of a human hair. The filters are tested and certified by NSF International to NSF/ANSI Standard 42 for material requirements only. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

We Also Recommend