Menu
Cart 0
Safety+PLUS 1/2 in. MIP Excess Flow Valve x 3/8 in. MIP x 36 in. Stainless Steel Gas Connector 3/8 in. O.D. (33,400 BTU)

Safety+PLUS 1/2 in. MIP Excess Flow Valve x 3/8 in. MIP x 36 in. Stainless Steel Gas Connector 3/8 in. O.D. (33,400 BTU)

Article Number:
  • $ 3902


1/4 in. I.D. (3/8 in. O.D.) corrugated stainless steel . Safety+PLUS EFV helps protect against gas fires and explosions . Safety+PLUS EFV installs like a standard gas fitting; no special tools required . Use to install dryers, decorative stoves and gas log fireplaces . ProCoat coating corrosion resistant to harsh chemicals as well as UV rays and salt . CSA certified to ANSI Z21.24/CSA 6.10 and ANSI Z21.75/CSA 6.27 . Approved for indoor and outdoor use . 1/2 in. MIP (3/8 in. FIP tap) connection to gas supply or gas ball valve . Safety+PLUS EFV has no parts that can wear, break or misalign over time for 24/7 protection . Safety+PLUS EFV is omnidirectional and can be installed in any position - vertical or horizontal . Use with natural and LP (propane) gases . Safety+PLUS EFV is 100% factory performance tested . Gas connector is 100% leak tested . Temperature rating: -20°F to 150°F . Pressure rating: 1/2 psi maximum

BrassCraft’s Safety+PLUS gas connector combines patented excess flow technology with the advanced corrosion resistance, to provide a safer gas connector for your home and family. In the event of a gas line rupture or disconnect, the Safety+PLUS excess flow valve (EFV) restricts gas flow at the appliance to a non-hazardous level. This immediate action helps avert the potential for a dangerous release of gas into the home. Gas is controlled only at the point where the problem exists; the rest of your system will continue to function. Safety+PLUS EFV automatically resets once the gas line is properly repaired. BrassCraft's stainless steel gas connector also features a proprietary polymer coating designed to withstand prolonged exposure to harsh household cleaning, plumbing repair and masonry products as well as UV rays and salt. Unlike conventional dipped or sprayed coatings, the ProCoat coating is baked directly on the connector surface at high temperatures to provide a uniform coating over the entire length of the connector. The coating is applied only after the connector has been 100% leak tested to provide the most complete corrosion resistance.

We Also Recommend